| Téléchargement | - Voir la version finale : A method for guiding efflux air from a fan-in-wing model into a discharge duct (PDF, 3.0 Mio)
|
|---|
| DOI | Trouver le DOI : https://doi.org/10.4224/40003771 |
|---|
| Auteur | Rechercher : Schaub, U. W.1; Rechercher : Rimmer, R. J.1 |
|---|
| Affiliation | - Conseil national de recherches Canada. Division de génie mécanique
|
|---|
| Format | Texte, Rapport technique |
|---|
| Description physique | 15 p. |
|---|
| Résumé | Ascheme is described by means of which the 12-inch fan-in-wing model in the Engine Laboratory was separated from a mechanically connected efflux-removing duct. The modifications that were introduced included a slotted bellmouth inlet, which served as a catch-flow entrance below the air gap, and a diffuser at the exit of the ducting system, which corrected the static pressure level in the duct for transmission of the full efflux flow.
The modifications were intended to facilitate mechanical isolation of the model so that direct lift measurements could be made while the efflux air was removed with essentially zero ground effect. |
|---|
| Date de publication | 1970-02 |
|---|
| Maison d’édition | National Research Council Canada |
|---|
| Série | |
|---|
| Langue | anglais |
|---|
| Publications évaluées par des pairs | Non |
|---|
| Numéro du CNRC | NRCC 11446 |
|---|
| Exporter la notice | Exporter en format RIS |
|---|
| Signaler une correction | Signaler une correction (s'ouvre dans un nouvel onglet) |
|---|
| Identificateur de l’enregistrement | 343a4a0a-f715-4f44-9788-9c2eaaacba47 |
|---|
| Enregistrement créé | 2025-10-01 |
|---|
| Enregistrement modifié | 2025-11-03 |
|---|
