| Téléchargement | - Voir la version de l’auteur : Influence of powder morphology and microstructure on the cold spray and mechanical properties of Ti6Al4V coatings (PDF, 1,7 Mio)
|
|---|
| DOI | Trouver le DOI : https://doi.org/10.1007/s11666-018-0729-8 |
|---|
| Auteur | Rechercher : Munagala, Venkata Naga Vamsi; Rechercher : Akinyi, Valary; Rechercher : Vo, Phuong1; Rechercher : Chromik, Richard R. |
|---|
| Affiliation | - Conseil national de recherches Canada. Automobile et les transports de surface
|
|---|
| Format | Texte, Article |
|---|
| Sujet | Armstrong; cold spray; nanoindentation; particle morphology; Ti6Al4V; titanium alloys |
|---|
| Résumé | The powder microstructure and morphology has significant influence on the cold sprayability of Ti6Al4V coatings. Here, we compare the cold sprayability and properties of coatings obtained from Ti6Al4V powders of spherical morphology (SM) manufactured using plasma gas atomization and irregular morphology (IM) manufactured using the Armstrong process. Coatings deposited using IM powders had negligible porosity and better properties compared to coatings deposited using SM powders due to higher particle impact velocities, porous surface morphology and more deformable microstructure. To evaluate the cohesive strength, multi-scale indentation was performed and hardness loss parameter was calculated. Coatings deposited using SM powders exhibited poor cohesive strength compared to coatings deposited using IM powders. Images of the residual indents showed de-bonding and sliding of adjacent splats in the coatings deposited using SM powders irrespective of the load. Coatings deposited using IM powders showed no evidence of de-bonding at low loads. At high loads, splat de-bonding was observed resulting in hardness loss despite negligible porosity. Thus, while the powders from Armstrong process lead to a significant improvement in sprayability and coating properties, further optimization of powder and cold spray process will be required as well as consideration of post-annealing treatments to obtain acceptable cohesive strength. |
|---|
| Date de publication | 2018-06-11 |
|---|
| Maison d’édition | Springer |
|---|
| Dans | |
|---|
| Langue | anglais |
|---|
| Publications évaluées par des pairs | Oui |
|---|
| Numéro du CNRC | NRC-AST-055 |
|---|
| Numéro NPARC | 23003716 |
|---|
| Exporter la notice | Exporter en format RIS |
|---|
| Signaler une correction | Signaler une correction (s'ouvre dans un nouvel onglet) |
|---|
| Identificateur de l’enregistrement | 26e1e0b0-bccd-454e-a402-4c854b19e9b1 |
|---|
| Enregistrement créé | 2018-08-03 |
|---|
| Enregistrement modifié | 2020-03-16 |
|---|
